FixMaster Concrete Floor Leveller is an industrial quality, rough surface smoothing compound for concrete. Easy to use, leaving a strong, non-dusting finish. Floor Leveller can be left as a wearing surface or sealed and coated with FixMaster Epoxy Paint WB to give a protective and decorative finish.

• Easy to use: pre-measured components
• Designed for warehouse, industrial floors and garages when rapid strength and durability are a high priority
• Two primers included, nearly all types of rough surface can be covered
• Fibre reinforced for a stronger, more durable surface
• Self smoothing
• Application depth from as little as 3mm up to 15mm
• Suitable for interior or exterior use
• Can be overpainted if a sealed or anti-slip surface is required

Specifications 
Surfaces: worn, rough or damaged concrete floors
Interior/Exterior: interior
Curing time: light traffic after 6-8 hours, full cure after 24 hours at 5mm. Thicker applications will take longer
Primer required: yes, included in pack
Coverage: 3.75m² @ 3mm thick, 2.2m² @ 5mm and 1.1m² @ 10mm per 25kg
Shelf life: one year in sealed containers
Floor Leveller should not be applied at less than 3mm or more than 15mm

Mixing & Application

Surface Preparation

Concrete should be clean and free from loose material. If the surface has previously been  painted the majority should be removed, especially if there are signs of loose or flaking edges. Small amounts of well bonded paint may remain, however if in doubt please call us. Do not apply to surfaces where sugar or sugar solution has been stored or allowed to contaminate the surface

Surface Priming

Two primers are supplied, primer 1 and primer 2.Primer 1 is to be used on porous surfaces. The concrete should be dampened with clean water, left for 30 minutes before evenly applying primer 1 with a brush or broom. Once dry primer 2 can be applied and the Floor Leveller mixed and laid straight onto primer 2 whilst still wet. Ensure to apply the primers evenly to avoid ponding as any excess primer can be drawn to the surface to leave a milky residue. This does  not  affect  the products strength but can create an uneven appearance and causes problems with over coating.

Mixing

Whilst mixing, pour the resin into the tub and slowly add the powder. Mix using a drill fitted with a mixing blade until a uniform, lump free consistency is obtained, this will take approximately 3-4 minutes.

Application

Do not apply below 5°C or above 25°C. Pour the mixed slurry straight onto the wet primer 2 and spread evenly at the desired thickness using a steel float. Any marks from spreading will level out. A spiked roller to release air should be passed through the Floor Leveller 3 or 4 times at different directions within 15 minutes of pouring to ensure roller marks do not remain visible when dried. Where possible, try to avoid applications being left to cure in direct sunlight as this can cause hairline cracking.

Download TDS

Download SDS