An epoxy floor paint with excellent abrasion, wear and chemical resistance. Ideal for industrial or commercial floors, vehicle maintenance bays, garages, laboratories, showrooms, schools, plant rooms and food & beverage production areas.

• Pre Dispersed polymer aggregate ensure even distribution and excellent results
• Cures to a textured high gloss finish
• Surface usable in 24hrs 
• Extremely hard wearing, with good abrasion resistance
• Good oil and chemical resistance
• 100% solid epoxy formula
• Solvent free and virtually odourless

Application video for Epoxy Paint?100

Surface Preparation
New concrete should be at least 4 weeks old. surfaces should be clean and dry. Smooth or new concrete should be either mechanically abraded or acid etched. Grease, oil and other contamination can be removed using FixMaster Master Bio-Clean or similar degreasant. Epoxy Coat Gloss WB can be applied over existing coatings but they must be well bonded and lightly abraded. Wooden surfaces should be abraded to remove dirt. Two or three coats may be required on porous wooden surfaces. Not recommended for use on metal or most latex levelling compounds.

Mixing
Epoxy Paint Gloss WB is supplied in pre-weighed containers and should be mixed in full. Stir the two components separately before mixing together thoroughly.

Mixing should be carried out by drill with a suitable mixing attachment or wide bladed tool. Mix continuously for 2-3 minutes until a uniform colour and consistency is achieved. 

Application
One coat will act as a priming and sealing coat. The second coat will provide a uniform attractive finish and can be applied as soon as the first coat is dry. Application is best in a temperature between 15-25°C with a medium pile simulated sheepskin roller. Do not apply to a floor temperature below 5°C and avoid washing the floor for 7 days.

Specifications
Surfaces: concrete, wood or metal
Interior/Exterior:  interior
Curing time: at 20°C the area can be opened to light traffic after 24 hours
Primer required?:  very porous surfaces should be sealed with Epoxy Prime 100
Coverage: 5m² per kg at 200 microns thick
Number of coats: One coat is normally sufficient, some surfaces may require a 2nd coat for a completely uniform colour
Shelf life: one year in sealed containers

 Pendulum Slip Test Values

Dry PTV: 58 – Low slip potential

Wet PTV: 42 – Low slip potential

Download TDS

Download SDS